Free gravel estimates and delivery quotes from local suppliers
Get instant estimates for your Artesia project
Rough material estimate based on typical published prices. Delivery is extra, often $50–$150+ per load depending on distance. Actual prices vary by supplier, so request a quote for exact pricing.
Fill out the form below and we'll contact you with pricing and availability
Need caliche for a driveway, road base for a yard, or crushed limestone for a pad? Use the free calculator above to estimate how much material you need, then request a quote. We help you get delivery quotes from local suppliers serving Artesia and the surrounding area, including Carlsbad, Loving, Hope, and Lake Arthur.
Artesia sits in Eddy County in the Permian Basin, where oil and gas work, ranching, and farming keep demand steady for caliche and base materials. Here's a quick guide to the materials people in the area ask about most.
Caliche is a natural material found across arid regions like southeast New Mexico. Calcium carbonate cements soil, sand, and rock together into a hard, whitish-tan layer. It's commonly used for rural driveways, ranch roads, lease roads, and pads.
Caliche is usually cheaper than manufactured base. It compacts hard when it's watered and rolled, but quality varies from pit to pit. Caliche with a lot of fines can turn soft or muddy when soaked and dusty when dry, so ask your supplier about the source.
Crushed limestone is quarried and screened to consistent sizes. Many people choose it over caliche when they want a more uniform base, a cleaner top layer for a driveway, or material for heavier traffic.
Ask your supplier which size you need. Fine grades with dust compact well for base, and clean stone drains better.
Road base, also called base course, is a mix of crushed rock and fines made to compact into a firm layer. It goes under driveways, parking areas, sheds, and slabs. For residential driveways, 4 to 6 inches of compacted base is a common range. Heavier traffic or soft ground may need more.
Fill dirt is used to raise grade, fill low spots, and backfill around foundations and trenches. Sand is used for bedding pipe, setting pavers, and leveling under slabs. Both are sold by the ton or the cubic yard, so confirm which your quote uses.
Caliche is widely used for well pads and lease roads in southeast New Mexico. For example, one federal surface use plan filed for a well in neighboring Lea County calls for a driving surface of 6-inch rolled and compacted caliche. On federal land, caliche usually has to come from a BLM-approved pit with a permit, so check your project's requirements before you order. If you're a contractor or operator in the Artesia area, request a quote with your volume and timeline.
Multiply length × width × depth in feet, then divide by 27 to get cubic yards. Multiply cubic yards by the material's weight to get tons.
Example: a 100 ft × 12 ft caliche driveway at 6 inches deep is about 22.2 cubic yards. At roughly 1.2 tons per yard, that's about 26.7 tons. Weights vary by material and moisture, so confirm the tons-per-yard figure with your supplier before you order by weight. The calculator above does this math for you.
For a lightly used rural driveway in a dry climate, caliche is a cost-effective choice. It compacts hard when watered and rolled. The downsides are dust when dry, possible soft spots when soaked, and inconsistent quality between pits. Many people use caliche as the base and add crushed rock or limestone on top.
4 to 6 inches compacted is common for residential driveways. Heavy trucks, equipment, or soft and clay ground usually call for more, often 6 to 8 inches or deeper. For engineered projects, follow the project spec.
No. New Mexico Gravel is a free estimate and quote service. We connect you with local suppliers, and the supplier you choose handles pricing, the material, and delivery.
Yes. See our pages for Carlsbad, Hobbs, Lovington, and Roswell.